السلام عليكم
اخواني بعد تركيب البرنامج على اللينوكس بقي عليي تجهيز البورت وكم شغلة
وهذا مثال
Special notice for VPS/VDS installs:
After the install, add:
ethernet_dev=eth0:devicename
to /usr/local/directadmin/conf/directadmin.conf.
Replace devicename with the FULL devicename reported by ifconfig. If your VDS/VPS system emulates eth0, then you may skip this step.
Setup SSL Certificates:
This step is only required if you wish to use DirectAdmin through SSL. You will also have to change set SSL=1 in the directadmin.conf file.
# openssl req -new -x509 -keyout /usr/local/directadmin/conf/cakey.pem.tmp \
-out /usr/local/directadmin/conf/cacert.pem
# openssl rsa -in /usr/local/directadmin/conf/cakey.pem.tmp \
-out /usr/local/directadmin/conf/cakey.pem
# rm /usr/local/directadmin/conf/cakey.pem.tmp
# chown diradmin:diradmin /usr/local/directadmin/conf/cakey.pem
# chmod 400 /usr/local/directadmin/conf/cakey.pem
Named Reload Bug (RedHat 7.2 Only)
Make sure that the /etc/rndc.conf file has the following data for the "server localhost" directive:
# cat /etc/rndc.conf
...
server localhost {
key "rndckey";
};
...
If you don't see that anywhere, use an editor such as pico or vi to make the file contain the above text.
Accessing the Control Panel
DirectAdmin can be accessed at
http://server.ip.address:2222 -- use the Admin username/password specified in the setup.txt file in your scripts directory.
Dealing with RPM errors
When installing RPMs, errors can sometimes occur. Don't panic, solving them is usually easy. If you didn't know what to install during your RedHat installation, you might have installed a few services, such as apache and sendmail. These services must be removed before the rpm will be able to be installed.
For example, lets say you are trying to install exim and you get the following:
# rpm -ivh exim-3.36-2.i386.rpm
Preparing... ########################################### [100%]
file /somefile from install of exim-3.36-2 conflicts with file from package sendmail-8.1
...
This would mean that sendmail is already installed on your server and you must remove it. This can easily be accomplished by running the following:
# rpm -e --nodeps sendmail
Then you will be able to install your rpm. This follows for other services such as apache, apache-devel, wu-ftp, php, MySQL and so forth. If you need to figure out if you already have a service installed, you can run
# rpm -q servicename
or
# rpm -qa | grep substring
Where substring is just a word. For example, using "apache" might return:
# rpm -qa | grep apache
apache-fp-1.3.27-2
apache-fp-devel-1.3.27-2
apache-fp-manual-1.3.27-2
Troubleshooting
If you are having trouble with RPMs hanging, please look at:
http://bugzilla.redhat.com/bugzilla/...cgi?i d=73097
..........
يا ريت حد يضيفني على الماسنجر ويساعدني
MSN:
support@altirahost.net